Chassis and Power Supplies
Mounting the Switch
OmniSwitch 10K Hardware Users Guide
August 2015
page 2-7
Airflow Recommendations
To ensure proper airflow, be sure that your switch is placed in a well-ventilated area and provide
minimum recommended clearance at the front, back and sides of the switch, as shown below. Restricted
airflow can cause your switch to overheat, which can lead to switch failure.
Chassis Top View
Note.
Clearance is not required at the top and bottom of the chassis.
OmniSwitch 10K fan trays draw air from the intake vents located at the bottom-front and left and right
sides of the chassis. The air is directed up through the chassis’ module compartment and past the CMM,
CFM and NI circuit boards. Airflow is then exhausted through the vent at the top-rear of the chassis.
}
}
Rear.
6 inches minimum
at rear of chassis.
Front.
6 inches minimum
at front of chassis.
Sides.
2 inches minimum
at left and right sides.
Chassis Front View
Chassis Rear View
Содержание OmniSwitch 10K
Страница 1: ...Part No 060310 10 Rev H August 2015 OmniSwitch 10K Hardware Users Guide enterprise alcatel lucent com ...
Страница 8: ...Contents viii OmniSwitch 10K Hardware Users Guide August 2015 ...
Страница 18: ...OmniSwitch 10K Availability Features OmniSwitch 10K page 1 4 OmniSwitch 10K Hardware Users Guide August 2015 ...
Страница 64: ...Pinouts Chassis Management and Fabric Modules page 3 16 OmniSwitch 10K Hardware Users Guide August 2015 ...
