Alcatel-Lucent OmniAccess 700, Руководство по настройке CLI

Страница: 970 / 1193

Quality of Service
Left running head:
Chapter name (automatic)
944
Beta Beta
CLI Configuration Guide
Alcatel-Lucent
A
UTO
Q
O
S C
ONFIGURATION
AutoQoS is a feature that enables user to configure QoS on the OA-700 with
minimal effort. Normally, QoS configuration involve definition of class, match list
association with the class, definition of policy, class association with the policy and
defining class traffic attributes like bandwidth, police, shape, etc. This entire
configuration might be cumbersome for user to configure.
Auto QoS commands creates QoS configuration - automatically classifies traffic,
applies the required traffic attributes for each of the classes based on the class
needs. Auto QoS configuration automatically gets enabled on the interface. These
configurations are not editable.
Note: Auto QoS commands are available only in the Interface Configuration mode.
V
O
IP A
UTO
Q
O
S C
ONFIGURATION
Auto QoS VoIP create policies and classes as required by VoIP application.
VoIP Auto QoS is typically configured on the Serial Interface (that has HDLC and
PPP encapsulation). This is to achieve low-latency on the serial interfaces or
Point to Point link.
Note: Auto VoIP configurations are applied only in the egress direction of the interface as
queuing in involved.
T
O
C
ONFIGURE
A
UTO
Q
O
S V
O
IP
E
XAMPLE
ALU(config-if Serial0/1:3)# auto qos voip
ALU(config-if Serial0/1:3)# no auto qos
Command (in ICM) Description
auto qos voip
This command enables Auto QoS VoIP
on an interface.
no auto qos voip
This command disables Auto QoS VoIP
on an interface.