Alcatel-Lucent OmniAccess 700, Руководство по настройке CLI

Страница: 87 / 1193

AAA Configuration on OA-700
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
61
Alcatel-Lucent
Beta Beta
CLI Configuration Guide
T
O
A
DD A
RADIUS S
ERVER TO THE
RADIUS S
ERVER
G
ROUP
E
XAMPLE
ALU(config-srv-grp-rad1)# radius-server 1.1.1.1
ALU(config-srv-grp-rad1)# no radius-server 1.1.1.1
T
O
C
ONFIGURE
RADIUS S
ERVER
G
ROUP
G
LOBAL
O
PTIONS
Note: In the Configuration mode, you can configure RADIUS server global options like
timeout, key, and authentication port. You can also configure these values on a per
server basis. Per-server values should be entered in the RADIUS Server Group
Configuration Mode.
The per-server parameters override the global ones, in case both are configured.
Default global values for these parameters exist that will come into effect if neither per-
server nor global values are configured explicitly.
The following are the RADIUS server options:
•
Authentication Port (auth-port): This is the destination port on which the RADIUS
server is listening.
•
Deadtime: The time (in minutes) that should elapse, before you again try to
connect to a non-responding server.
•
Key: This is the encryption key between the OA-700 and the RADIUS server.
•
Timeout: This determines the number of seconds that the OA-700 should wait for
a reply from the RADIUS server before retrying.
•
Retransmit: The number of retries after each “timeout” interval, before giving up
on the server.
Command (in RADIUS Server
Group CM)
Description
radius-server <ip-address>
[{ auth-port < 1-6000 >
| deadtime < 1-1440 >| key { 5
[ string ]| <string >}|
retransmit < 1-100 >| timeout
< 1-1000 >}]
This command is used to add the RADIUS
server of the specified IP address into
RADIUS server group.
You can also specify the server specific
parameters like auth-port port-number, dead
time, key string, etc.
no radius-server <ip-
address>
This command removes the RADIUS Server
from the server group.