DECT handsets Unified Support Tool
8AL90330ENADed01
6
/
25
For 8212, 8232 and DECT Intercom, a specific USB/jack 3,5mm 4 points adapter module is required: 8212
/ 8232 DECT serial interface for PFWU/UST (3BN67339AA /3BN67339AB
).
8232 HW version must V7Rx or higher.
Warning
Files with “.HEX” or other extensions shall be used for 8212 / 8232 exclusively.
Also using a file with extension “.BIN” or .HEX but with a wrong content (another file
format renamed to “.BIN” or “.HEX ” not intended for the 8242, 8262, 8212 or 8232 can
lead to a failed upgrade and worse to a non-operational device.
Installation UST on a PC (Win7, Win8.1 or Win10)
UnifiedSupportTool-Setup-vX.exe contains the Windows installer for the Unified Support tool.
Run UnifiedSupportTool-Setup-vX.exe and follow the Windows installer.
Warning
A specific driver from Silicon Labs (USBtoUARTBridgeVCP) is needed for the use of
the dongle (8212 / 8232). If necessary, the Windows installer prompts you to install it.
Setup Check List
Before upgrading any handsets, then please go through the following check list, and verify that your setup
meets the requirements.
•
Check that your PC runs Windows 7, Windows 8.1 or Windows 10.
•
Check that your PC USB port is 2.0,
do not use USB 3.0.
•
Check that your PC runs .NET Framework >= to v4.5
•
You have
admin rights
on your PC in order to allow program rights elevation
•
Check the USB hub Black/White list before connecting the hub.
•
Check that the 8242 or 8262 desktop charger cradle (dual or simple) is connected to a Power
Supply Unit (PSU) AC/DC adapter and to the USB hub for the data cable.
•
Minimum resolution to fit the dialog without cropping is 1280*720 (at 100% scaling in windows
display properties)
•
For the 8212 / 8232 / DECT Intercom, check that you have the right USB/jack adapter module (No
USB connector on 8212 / 8232)
8212 / 8232 DECT serial interface for
PFWU/UST -
3BN67339AA / 3BN67339AB
