Albo marine MG 309, Руководство по эксплуатации

Страница: 41 / 43

TABLE 3. TROUBLESHOOTING AND GENERATOR SET FAULTS (Continued)
Fault-Problem Possible reasons Remedies
Speed lamp is turned on.
Excessive output voltage,
Excessive output
frequency

Circuit breaking fuse error

Check and replace the circuit
breaking fuse

There may be a fault on the fuel
system

Repair fuel leaks in the fuel system
and remove air bubbles remaining
in the system.

There may be air inside the fuel
system

Bleed the air of fuel system
properly.

Voltage adjustment regulator is
faulty

Correct the adjustments

Alternator is faulty

Contact an authorized dealership.

Speed lamp is turned on.
Excessively low output
voltage, Excessively low
output frequency

PTO takes too much energy from
the engine

Disable the PTO.

Excessive electrical load

Turn off the devices with high
resistance (electrical loads like spot
lights, heaters, big A/Cs, water
heaters etc.)


There may be a fault on the fuel
system

Repair fuel leaks in the fuel system
and remove air bubbles remaining
in the system.


There may be air inside the fuel
system

Bleed the air of fuel system
properly.


Fuel quality may be improper

Use fuel with quality conforming
with the specifications specified by
engine manufacturer


Engine operating air is inadequate

Provide air required for the ignition
of the engine


Voltage adjustment regulator is
faulty

Correct the adjustments


Alternator is faulty

Contact an authorized dealership.

Speed lamp is turned on.
Engine is not operating
with adequate speed.

PTO takes too much energy from
the engine

Disable the PTO.

Electrical charge in startup is too
much.

Reduce electrical load.


Inadequate battery charge, loose
contact in battery cables and
connection points

Clean the terminals. Check battery
charge and cables. Tighten
connections.


Improper oil for the operating
conditions may be used

Use proper oil for the operating
conditions.

6
–4