Alber Universal Xplorer UXIM, Руководство по установке

Страница: 15 / 42

System Installation
4200-106 4-1 Revision 3
4. System Installation
Note : The UXIM must be installed in a restricted access location.
UXIM installation requires nothing more than standard hand tools, cutters, strippers and screwdrivers. If
the unit is to be wall mounted, a drill will also be required.
The following is a list of the steps required for successful UXIM system installation. Some items may not
apply due to system requirements.
Installation Task Refer to Section
Verify materials ordered and received Materials Received List, page 5-1
Items to consider before system installation System Installation Considerations, page 6-1
Isolate the battery string Battery String Isolation, page 6-1
Identify cell/monobloc Number 1 Cell Number 1 Identification, page 6-1
Properly install the tab washers Installation of Tab Washers, page 7-1
Configure the unit Unit Configuration, page 8-1
Mount the equipment Equipment Mounting, page 9-1
Connect the sense lead harnessing Sense Lead Harness Connection, page 10-1
Connect the fused load lead harnessing Fused Resistance Load Lead Harness Connection,
page 11-1
Connect the ambient temperature sensor Charger Cable Resistance Reading Connection, page
12-1
Connect the digital inputs if applicable Digital Inputs Connection, page 14-1
Connect RS-485 communications if applicable RS-485 Communication Connection, page 15-1
Connect the fiber optic interface if applicable Fiber Optic Communication Connection, page 16-1
Connect the Network communications if
applicable Network Communication Connection, page 17-1
Connect the alarm contacts if applicable Parameter Alarm Connection, page 18-1
Connect the Hardware alarm contacts if
applicable Hardware Alarm Connection, page 19-1
Table 1 - Installation Task List