Albemarle 280 EXPRESS FISHERMAN, Руководство пользователя

Страница: 48 / 124

280 Series Express Fisherman
48
5.3 Hot Water Heater (Optional)
The water heater is located in the bilge below the cockpit fish-
box. All heaters have a 120-volt element that is thermostati-
cally controlled at the heater and activated by a circuit breaker
located in the 120-volt panel. A high pressure relief valve
protects the system from excessive pressure. Always make
sure all air is purged from the hot water heater and lines before
activating the water heater breaker. Refer to the water heater
owner’s manual for additional information.
DO NOT SUPPLY CURRENT TO AN EMPTY WATER
HEATER. DAMAGE TO THE HEATER WILL RESULT.
THE SYSTEM MUST BE FILLED AND PRIMED
BEFORE ACTIVATING THE WATER HEATER.
5.4 Shower Operation
To obtain the most consistent temperature, open the cold wa-
ter faucet, then gradually open the hot water faucet until the
desired temperature is obtained. Some minor variations in the
water temperature may occur as the pressure pump cycles.
Shower water is drained from the boat by a sump pump sys-
tem connected to the shower drain. The pump is protected
and activated by the shower sump pump circuit breaker in the
DC panel. Make sure this breaker is on before using the shower
and turn it off immediately when done.
After showering, let the cold water flow for a period of time to
flush the drainage system of soap residue.
Note: The shower drain strainer must be cleaned regu-
larly. It is also essential that the sump be inspected
periodically for accumulated debris that needs to
be removed.
Water Heater
Shower Drain Sump Pump