Alaxala AX6300S series, Руководство пользователя программного обеспечения

Страница: 131 / 522

5. IEEE802.1X
115
Example
Figure 5-19: Initializing all IEEE 802.1X authentication statuses on a Switch
> clear dot1x auth-state
Initialize all 802.1X Authentication Information. Are you sure? (y/n) :y
>
Display items
None
Impact on communication
If initialization is performed, the IEEE 802.1X authentication status on the relevant ports or
VLANs is initialized, and communication is lost. To restore communication, re-authentication is
necessary.
Response messages
Table 5-6: List of response messages for the clear dot1x auth-state command
Notes
When authentication status is initialized, EAP-Failure or EAP-Req/Id might be sent according to
the specified parameter.
• If the parameter is omitted, EAP-Failure and EAP-Req/Id are multicasted once to all types of
IEEE 802.1X authentication in a Switch.
• If the parameter is
port
<port list> ,
channel-group-number
<channel group list> ,
vlan
<vlan id list> , or
vlan dynamic
, EAP-Failure and EAP-Req/Id are multicasted once to the
specified type of IEEE 802.1X authentication.
Message Description
Can't execute this command in
standby system.
This command cannot be executed on a standby system.
Can't execute. The command could not be executed. Re-execute the command.
Connection failed to 802.1X
program.(Reason:Connection Error)
An attempt to connect to the IEEE 802.1X program failed. Re-execute the command.
If the failure occurs frequently, use the
restart dot1x
command to restart IEEE
802.1X.
Connection failed to 802.1X
program.(Reason:Receive Error)
An attempt to receive data from the IEEE 802.1X program failed. Re-execute the
command. If the failure occurs frequently, use the
restart dot1x
command to
restart IEEE 802.1X.
Connection failed to 802.1X
program.(Reason:Send Error)
An attempt to send data to the IEEE 802.1X program failed. Re-execute the
command. If the failure occurs frequently, use the
restart dot1x
command to
restart IEEE 802.1X.
Dot1x doesn't seem to be running. The IEEE 802.1X setting has not been enabled. Check the configuration.
No operational Channel Group. There are no available channel groups. Check the authentication mode set by the
configuration.
No operational Port. There are no available ports. Check the authentication mode set by the configuration.
No operational VLAN(Dynamic). VLAN-based authentication (dynamic) was not configured. Check the
authentication mode set by the configuration.
No operational VLAN. There are no available VLANs. Check the authentication mode set by the
configuration.
Now another user is using dot1x
command, please try again. Another user is using the
dot1x
command. Wait a while, and then retry the
operation.