Alarm Lock Trilogy DL2800, Инструкция по программированию

Страница: 6 / 36

6
First Time Start Up
IMPORTANT: Failure to follow this exact procedure can result in erratic lock behavior.
The DL2800 lock uses five (5) AA-size 1.5 volt alkaline batteries. Remove the back cover, install batteries into the battery
pack. Connect the battery pack plugs and the lock will beep 3 times. To load the default program press any key within 5 sec-
onds, the lock will beep slowly while the default values are loaded and beep rapidly upon completion.
Enter Program Mode and Change Factory Master Code
1. Press the default Master Code:
1 2 3 4 5 6
.
2. Wait for the green light and press
;
until multiple beeps are heard. You are now in Program Mode.
(Note: The lock will beep every 6 seconds as a reminder that you are in Program Mode).
3. Enter a new personal 6-digit Master Code number by pressing the following keys:
; 1 ;
[
new Master Code
]
;
[
new Master Code
]
:
(the second set of digits must be exactly the same).
(For example, if you want your new Master Code to be “664433”. Press:
; 1 ; 664433 ; 664433 :
).
Now that the Master Code has been changed, there is no need to change it again (unless you want to). Since you
are still in Program Mode, you can now proceed directly below and program various functions.
Note: Program-
ming any Function, such as setting the time, follows a consistent 5-step pattern: (1) Enter Program Mode (2)
Press
;
[Function #]
(3) Press
;
and enter data (4) Press
:
to end (5) Exit Program Mode (if desired).
Set the Weekday
1. Enter Program Mode (if not in already).
2.
Press
; 40 ;
[
number of weekday
]
:
. (Use 1= Sunday, 7 = Saturday).
(For example - Friday - press
; 40 ; 6 :
).
Set the Date
1. Enter Program Mode (if not in already).
2.
Press
; 38 ;
[
MMDDYY
]
:
.
(For example - May 10, 2002 - press
; 38 ; 051002 :
).
Set the Time
1. Enter Program Mode (if not in already. If you just finished the above procedure, you are still in Program Mode).
2. Press
; 39 ;
[
HHMM
]
:
. (Use 24-hour military (HHMM) format, where PM adds 12 hours).
(For example - 2:30pm - press
; 39 ; 1430 :
).
Enter User Codes
1. Enter Program Mode (if not in already).
2.
Press
; 2 ;
[
User Number
]
;
[
User Code
]
:
.
(For example, John Smith is designated as User 21. You want him to use the User Code of “232323” to unlock the
lock. Program the lock by pressing:
; 2 ; 21 ; 232323 :
).
3. Repeat step 2 for each new User.
Exit Program Mode
Hold Down any key for 3 seconds. Program Mode exit is confirmed by several beeps. You are now in "normal" operation.
Re-enter Program Mode
If you wish to re-enter Program Mode, key-in your new 6-digit Master Code, and press
;
.
You are now ready to mount and install your DL2800 series lock and give out your User Codes. Before installation, it is sug-
gested you test and verify that all User Codes entered are active. Use the IR1 infrared printer (available separately) to print your
own audit logs and User Codes list.
Quick Start