54
MAINTENANCE
The Pump, lower housing, slide link and latch (Continued)
3. Set the pump upright.
4. Clean the slide link and pump latch mechanism using a small
soft-bristled brush (or lint free swab ) dampened with the
appropriate cleaning solution, as specified in the “Cleaning”
section. If dried residue is difficult to remove, or the slide link
or pump latch sticks, spray the cleaning solution on the
residue and allow it to soak until it can be more easily
removed.
5. After removing residue, rinse with a lint free swab dampened
with water. Water may be sprayed on the cleaned surfaces to
rinse areas that are difficult to reach with a swab.
6. Dry with a lint-free swab or cloth, or allow to air dry.
Air Sensor Recess
NOTE:
Air-in-line alarms may occur when dries residue
builds up in the air-in-line sensor tubing recess.
1. Inspect the air-in-line sensor module to ensure that there is
no separation or breakage of the glued seams.
NOTE:
Defective air-in-line sensor modules must be
replaced before using the instrument.
2. Place the instrument in the upright position.
3. Clean the tubing recess (using a downward motion) with a
lint free swab dampened with the appropriate cleaning
solution, as specified in the “Cleaning” section.
4. Rinse with a lint free swab dampened with water.
5. Dry with a lint-free swab or allow to air dry
.
To Clean (Continued)
SLIDE LINK ASSY.
PUMP LATCH
Use of abrasives or abrasive
cleaners on air sensor recess may
cause false Air-in-line or Check
Air Sensor alarms.
CAUTION
A
AIR SENSOR
A
Содержание MedSystem III
Страница 37: ...34 GETTING STARTED T H I S PA G E I N T E N T I O N A L LY L E F T B L A N K...
Страница 45: ...T H I S PA G E I N T E N T I O N A L LY L E F T B L A N K 42 ALARMS ADVISORIES AND PROMPTS...
Страница 61: ...58 MAINTENANCE T H I S PA G E I N T E N T I O N A L LY L E F T B L A N K...
Страница 63: ...T H I S PA G E I N T E N T I O N A L LY L E F T B L A N K 60 MAINTENANCE...
