Alaris Medical Systems MedSystem III, Инструкция по применению

Страница: 51 / 66

48
MAINTENANCE
3. Verify that the pump latch mechanism of each channel
returns to the
Home position at the top of the stroke
(nearest to the chassis).
4. Press the channel select key (A, B or C), and then press the
START/STOP key. A two-tone advisory will sound and the
highlighted message
Install Cassette will appear in the
prompt line near the bottom of the screen.
5. Install a primed cassette into the appropriate channel (A, B
or C), but do not push the cassette slide clamp into place.
Ensure that there are no air bubbles.
6. Press the START/STOP key again. A two-tone sound will be
emitted, and the message
Push Slide Clamp In will appear
at the bottom of the page.
7. Push the cassette slide clamp in and seat the tubing collar in
the recess below the cassette. Three beeps will sound to
indicate correct cassette installation and fluid in the sensor
pathway. The cassette should latch easily and smoothly. If
the air-in-line sensor detects air when a cassette is installed,
a
Check Air Sensor advisory will be displayed.
8. Press the START/STOP key. The message Infusing will appear
on the channel status line.
9. While the channel is pumping, pull out the cassette slide
clamp. You will hear a repeating four-beep audio alarm and
the red LEDs will blink. Infusion will stop and the display will
indicate a
Cassette Not Latched alarm.
10. Remove the cassette. The alarm display should read
Cassette Removed . Reset the alarm by pressing the channel
select key (A, B or C) for the channel in use, and press the
CANCEL softkey.
Cassette and Sensor Test (Continued)
Cassette Slide
Clamp
Tubing Collar
A
Slide Clamp Not In Place
Slide Clamp In Place