7
AK-SecurePowerSwitch Manual,
AK-SecurePowerSwitch
Front side
1.) Manual rocker switch with delay against accidental switching on.
Two functions can be attained by actuating these rocker switches:
1.) Factory default function.
All values of the
SecurePowerSwitch
are reset to factory settings. This function
is enabled by pressing the switch after switching on the
SecurePowerSwitch
until 2 signal tones sound. Then the switch may be released.
2.) Manually
switching
the relay on or off.
This function is enabled by actuating the switch for about 2 seconds. Then 2
signal tones sound and the switch may be released. It is possible to set the
actuating period of the switch in the configuration menu.
2.) Status
display
These LEDs indicate the following states:
On/Off
:
Indicates that the relays are switched on or off.
Network
:
Indicates that the
SecurePowerSwitch
is receiving or sending
network packages. It does not indicate the network activities. It is
directly indicated on the rear side of the RJ45 bushing.
PS state
:
Indicates the state of the process part. Should flash once per second
in case of an emergency.
PS error
:
Indicates an error, such as e.g. the relays are switched, but no current
flows since the terminal is still switched off.
1
2
