AJA IO LA, Инструкция по установке и эксплуатации, Страница: 41 / 76

1
33
Io LD and Io LA Installation and Operation Manual — Cabling the System
4. Insert two screws from the supplied bag through the chassis into the panel
below. Tighten the screws until they are snug. Do not over-tighten the screws.
5. Locate the two holes on the side of the rackmount chassis, next to where the
panel was mounted.
6. Insert two more screws in these holes and tighten them snugly as before.
7. If you have an additional panel to mount, repeat steps 2 through 5 and you’re
done. If mounting only one panel, procede to the next step.
8. Slide the blank panel assembly under the rackmount chassis so that the screw
holes in the blank panel align with those in the chassis. Insert four screws
through the chassis into the blank panel assembly and tighten them snugly.
Optional Rackmounting Kit
Cabling the System
Where to Place Io
•
Plan adequate space for cable routing from the back of the panel. Ensure that
cable connectors are not stressed and that cables are not bent or crimped.
•
When rackmounting, allow adequate airflow to the panel(s) and equipment
above and below it. Note the location of cooling vents on all equipment and
ensure none are obstructed.
•
Place the panel where temperature and humidity are moderate. Temperature
specifications are as follows:
Panel Temperature Specifications
Optional Rubber Feet
(4 places)
Panel Mounting Screws
2 on side and 2 underneath
Pan-head
screws
Flat-head
screws
Operating
Temperature
10˚C to 35˚C
(50˚F to 95˚F)
Storage
Temperature
-40˚C to 60˚C
(-40˚F to 140˚F)