FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1 41 www.aja.com
3. Connect a 1080i59.94 HD tri-level sync reference signal to one of the FS-HDR
Ref Loop BNCs, and connect a 75 ohm terminator to the other Ref BNC.
• The REF LED will light blue, indicating the FS-HDR is genlocked to reference.
• The Status menu GEN parameters will report Ref and indicate the format of
the incoming reference signal or OK.
• However, because the FS-HDR is still not receiving a compatible video input,
No Input, will be reported for IN1.
Video Format Status screen
Video Format Alarm Status screen
IN1
SDI 1
No Input
BKGD Black
1080i59
GEN Ref
1080i59
OUT1
1080i59
IN1
SDI 1
OK
BKGD Black
OK
GEN Ref
OK
Rate
59/29/23
4. Connect a 1080i59.94 SDI video source to the SDI 1 input BNC.
• The front panel will report 1080i59 and an OK status for SDI 1. This indicates
no alarm condition exists.
Video Format Status screen
Video Format Alarm Status screen
IN1
SDI 1
1080i59
BKGD Black
1080i59
GEN Ref
1080i59
OUT1
1080i59
IN1
SDI 1
OK
BKGD Black
OK
GEN Ref
OK
OUT1
1080i59
5. Disconnect one of the power cords, leaving the other attached.
• The front panel PWR LED will light red for the power supply with the
removed cord.
• The PS status will report PS1 (or 2) OFF.
6. Reconnect the power cable. The PWR LED for that power supply will light
blue and the power supply status will report OK.
This workflow confirms the FS-HDR powers up successfully and reports reference
and power supply alarms.
NOTE: FS-HDR Reference, Power Supply, and Video Format alarms can be disabled, if
desired. This will prevent the LEDs from going red, but will not affect SNMP or
front panel status displays.
FS-HDR Processing Examples
About FS-HDR Operating Modes
The FS-HDR has two operating modes.
• Single Channel Mode (4K/UHD) has one video processing channel capable
of 4K/UltraHD video, and supports up and down-conversion to and from HD
video.
• 4 Channel Mode (HD/SD) has four video processing channels capable of HD
video, and each channel supports independent up and down-conversion
between HD and SD video.
Both operating modes support various types of High Dynamic Range (HDR) and
Wide Color Gamut (WCG) video, and can perform conversions between them.
The appropriate FS-HDR operating mode should be selected first, because
parameter setting changes only affect the current operating mode.
To change the FS-HDR operating mode:
1. Press the
CONFIG
System button:
