Airzone ACUAZONE IBPRO32, Быстрое руководство по установке

Страница: 29 / 116

27
ES
EN
FR
IT
PT
DE
INTRODUCTION
Airzone systems enable the management of Master and Zone interfaces. Master thermostats enable mode management or
define the efficiency level with the Eco-Adapt function.
Important: This system has to admits the Blueface thermostat as Master thermostat.
To distinguish a Master interface from a Zone interface, check the next points:
- Blueface Master: Mode and Eco-Adapt icons shown in white color.
- Blueface Zone: Mode and Eco-Adapt icons shown in gray color.
TYPES OF SYSTEMS
Configuration Installation Master thermostat
Zoned
Indoor zoned ducted AC unit (compatible with control of radiant
elements) One master thermostat
per system
Mixed
Indoor zoned ducted AC unit and individual AC units (compatible with
control of radiant elements)
One master thermostat
per system
2-pipe Individual AC units (compatible with control of radiant elements)*
One master thermostat
per system
3/4-pipe
Individual AC units (compatible with control of radiant elements)*
Possibility of more than
one Master per system
*Note: AZDI6MZZON [C/R] Airzone actuator zone module can only control the radiant stage.
SYSTEM INSTALLATION
Before the Airzone system commissioning, please check:
•
The system is going to control works correctly without the Airzone system installed.
•
In direct expansion unit systems, the indoor unit wired thermostat has been installed.
Important:
For installations with radiant surfaces only, it is recommended the installation of buffer tanks.
In order to install properly your Airzone system, follow these steps:
Configure the typology of your system.
- Configure the microswitch of the main control board of the system (see paragraph Types of systems).
- Configure the microswitchs of the radiant element control module (check the technical sheet of this product).
Make all connections
(see Section
Assembly and Connection
)
.
- Connect the communication gateway.
- Connect all the elements of the system (thermostats, modules, etc.).
- Power the main control board.
Check all the assembly and the connection are correct
(see section Assembly and connection evaluation
)
.
Configure the system.
- Configure the secondary modules to associate them then to a main thermostat.
- Configure all the thermostats (see sections Initial setup and Advanced settings ).
If you have any other doubt, check the user and installation manuals.