Mounting
19
5.
Attach the ProST to the mounting bracket by performing the following:
a.
Slide an M10-spring lock washer and then an M10-plain washer onto each M10-hex
head screw (ensure lock washer is nearest to head of screw bolt).
b.
Align the mounting bracket's holes with the ProST's mounting holes as displayed below.
(The mounting bracket side that provides a groove for inserting a nut must be aligned with the
ProST's mounting hole that is nearest to the ProST's rear panel.)
c.
From the external sides, insert the M10-hex head screws through the mounting
bracket's holes and ProST's mounting holes. Loosely fasten with the M10-hex nuts.
6.
Adjust the horizontal positioning of the ProST (see "Web-Based Management" for ProST
antenna alignment using RSS measurements), and then tighten the two M10-hex head screws
with the M10 hex nuts.
Note:
A third-party thread-locking compound must be applied to the M10-hex head
screws to prevent the bolts from working loose.
Содержание ProST 4.9
