Airspan ProST 4.9, Руководство по установке оборудования

Страница: 35 / 56

Cabling The ProST
31
CONNECTING PROST TO A COMPUTER
The ProST typically interfaces with the subscriber's network/computer using the indoor SDA-1
Type II adapter to which the subscriber's PC connects. This adapter provides one 100BaseT
interface. However, optional IDU adapters (SDA-4S Type II or SDA-4S/VL Type II) are offered
that provide four (10/100BaseT) LAN ports for interfacing with the subscriber's LAN network.
Warning: Only subscriber terminal equipment (e.g. computer modem port) that is
designed for full compliance with TNV-1 telecommunication network connectivity can be
connected to the SDA-1. Warranty of Airspan's equipment shall be made void if the SDA-1
is connected to a computer that is not compliant with TNV-1.
Using SDA-1 Type II
The SDA-1 Type II provides a single 100BaseT interface with the subscriber's LAN network.
The cable setup for ProST-to-LAN connectivity is as follows:
Cable: Straight-through CAT 5 Ethernet cable
Connectors: 8-pin RJ-45
Connector pinouts:
Pin Function
1 Tx+
2 Tx-
3 Rx+
6 Rx-
Once you have
connected the ProST to the SDA-1 , you can connect the ProST to the
subscriber's computer, as described below.
To connect the ProST to the subscriber's network/PC (via SDA-1):
1. Plug the supplied Category 5 Ethernet cable into the SDA-1's RJ-45 port labeled
LAN/PC .
2. Plug the loose end of the Category 5 Ethernet cable into the computer's LAN port.