Airpress LHR 215/5, Инструкция по эксплуатации

Страница: 14 / 19

12
Problem Possible Correction
Air leaks at the check
valve or at the
pressure relief valve. A defective check valve results in a constant air leak at the
pressure release valve when there is pressure in the tank
and the compressor is shut off. Drain the tank, then
remove and clean or replace the check valve.
Air leaks between
head and cylinder. Be sure of proper torque on head bolts. If leak remains,
contact a service technician.
Air leak from safety
valve. Operate the safety valve manually by pulling on the ring. If
the valve continues to leak when in the closed position, it
should be replaced.
Pressure reading on
the regulated pressure
gauge drops when an
accessory is used. If there is an excessive amount of pressure drop when the
accessory is used, replace the regulator.
NOTE: Adjust the regulated pressure under flow conditions
(while accessory is being used). It is normal for the gauge
to show minimal pressure loss during initial use of the tool.
Excessive tank
pressure. Move the Auto-On/Off lever to the Off position. If the unit
doesn't shut off, unplug it from the power source and
contact a service technician.
Motor will not start. Make sure power cord is plugged in and the switch is on.
Inspect for the Proper size fuse in your circuit box. If the
fuse was tripped reset it and restart the unit. If repeated
tripping occurs; replace the check valve or contact your
service technician.
Excessive moisture in
the discharge air. Remove the water in the tank by draining after each use.
High humidity environments will cause excessive
condensation. Utilize water filters on your air line.
NOTE: Water condensation is not caused by compressor
malfunction. Be sure thecompressor's air output is greater
than your tool's air consumption rate.
Air leaks from the tank
body or tank welds. Never drill into weld or otherwise modify the air tank or it
will weaken. The tank can rupture or explode. Compressor
cannot be repaired. Discontinue use of the air compressor.