Airpress LHR 215/5, Инструкция по эксплуатации

Страница: 7 / 19

5
tank may reduce the tank's strength and cause an extremely hazardous
condition. Welding on the tank in any manner will void the warranty.
Check the manufacturer's maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated so as to never
exceed the maximum pressure rating of the tool.
High temperatures and moving parts are present under the shroud. To prevent
burns or other injuries, DO NOT operate with the shroud removed. Allow the
compressor parts to cool before handling or servicing.
Be certain to read all labels when you are spraying paints or toxic materials, and
follow the safety instructions. Use a respirator mask if there is a chance of
inhaling anything you are spraying. Read all instructions and be sure that your
respirator mask will protect you.
Do not adjust the pressure switch or relief valve for any reason. Doing so voids
all warranties. They have been pre-set at the factory for the maximum pressure
of this unit.
Pull the pressure relief valve ring daily to ensure that the valve is functioning
properly, and to clear the valve of any possible obstructions.
Fasten the compressor down securely if transporting is necessary. Pressure
must be released from the tank before transporting.
Protect the air hose and electrical cord from damage and puncture. Inspect
them weekly for weak or worn spots, and replace if necessary.
DISCONNECT POWER AND RELEASE ALL PRESSURE FROM THE
SYSTEM BEFORE ATTEMPTING TO INSTALL, SERVICE, RELOCATE OR
PERFORM ANY MAINTENANCE.
GLOSSARY
Cut-in Pressure
: The air compressor will automatically start to the tank when
the pressure drops below the prescribed minimum.
Cut-Out Pressure : The point at which the motor stops when the tank has
reached maximum air pressure,