Airpress LHR 215/5, Инструкция по эксплуатации

Страница: 10 / 19

8
Location of the Air Compressor
The air compressor should always be located in a clean, dry, and well-ventilated
environment. The unit should have at minimum, 12 inches of space on each
side. The air filter intake should be free of any debris or obstructions. Check the
air filter on a daily basis to be sure it is clean and in working order.
Grounding Instructions
This product should be grounded. In the event of an electrical short circuit,
grounding reduces the risk of lectric shock by providing an escape wire for the
electric current. This product is equipped with a cord having a grounding wire
with an appropriate grounding plug. The plug must be plugged into an outlet that
is properly installed and grounded in accordance with all local codes and
ordinances Check with a qualified electrician or service personnel if these
instructions are not completely understood or if in doubt as to whether the tool is
properly grounded.
WARNING
Improper installation of the grounding plug will result in a risk of electric shock. If
repair or replacement of the cord or plug is necessary, do not connect the
grounding wire to either flat blade terminal. The wire with insulation having an
outer surface that is green with or without yellow stripes is the grounding wire.
Check with a qualified electrician or serviceman if the grounding instructions are
not completely understood, or if in doubt as to whether the product is properly
grounded. Do not modify the plug provided; if it will not fit the outlet, have the
proper outlet installed by a qualified electrician.
This product is for use on a circuit having a nominal rating of 230 volts and is
factory-equipped with a specific electric cord and plug to permit connection to a
proper electric circuit. Make sure that the product is connected to an outlet
having the same configuration as the plug. No adapter should be used with this
product. If the product must be reconnected for use on a different type of electric
circuit. qualified service personnel should make the reconnection.
CAUTION
Never use an extension cord with this product. Use additional air hose instead
of an extension cord to avoid power loss and permanent motor damage.
Break in Procedures
No break in procedure is required by the user. This product is factory tested to
ensure proper operation and performance.