Airbus TDM880i, Инструкция по эксплуатации

Страница: 23 / 37

TDM880i - Instruction Manual PS11129BENAC01
23/36
This document is the property of Airbus DS SLC and should not be copied or circulated without permission.
P A R A M E T E R R E F E R E N C E ( T D M 8 8 0 I S P E C I F I C P A R A M E T E R S )
Parametrization of Sleep mode functionality
Figure 4 Sleep mode configuration
In TPT configuration, the user is able to select the Operating mode, Sleep, Wake, and Activation periods as defined
in the Sleep mode parameters.
AT interface
Parametrization of the Sleep mode functionality:
Table 4 Sleep mode parametrization: AT interface
SDS interface
Parametrization of the Sleep mode functionality over an SDS message requires that the message format presented
below is used.
Table 5 Sleep mode parametrization: SDS interface
After a new configuration is retrieved, a special acknowledgement message is sent to the configuration sender. The
format of the acknowledgement is as follows:
Table 6 Acknowledgement message format
DESCRIPTION COMMAND RESPONSE
Sleep mode off +CXSLMS=0 OK
Sleep mode configuration password, +CXSLMS=[mode], [waketime],
[sleeptime], [Activation time] OK, FAIL
FIELD TYPE
Protocol Identifier SDS_TL_GENERAL_OTA_ID
Sub-protocol Identifier SDS_TL_SLEEPMODE_OTA_ID [
Message Length unsigned byte. Note! Includes both protocol identifiers and the payload length
Payload char[n] : [mode],[sleeptime],[waketime],[activation time]
FIELD DESCRIPTION
Protocol Identifier SDS_TL_GENERAL_OTA_ID
Sub-protocol Identifier SDS_TL_SLEEPMODE_OTA_ID [
Message Length 1 byte
Status 1 = success
0 = failure
Note: The acknowledgement message requires that at least the protocol and sub-protocol identifiers are
correct.