LoadLifter 5000 Series
MN-1053
11
CAUTION
4. Raise the axle or lower the frame down so that the thick spacer (F) on the upper
bracket is parallel to and contacts the frame (on both sides) (Fig. 16).
5. Install the 3/8”-16 serrated lock nut (U) on the carriage bolt (M) that went through the
existing jounce bumper hole and torque to 35 lb.-ft. (47Nm) on both sides (Fig. 17).
BE SURE NOT TO PINCH THE PREVIOUSLY MOVED WIRING OR LINES INSIDE THE
LEFT FRAME RAIL.
6. Cap the brace/upper bracket carriage bolts (P) with two 3/8” flat washers (Z) and two
nylon lock nuts (Y) and torque both to 35 lb.-ft. (47Nm) on both sides (Fig. 17).
7. With the spacers (F) on the upper brackets tight to the bottom of the frame and the
braces tight to the upper bracket, tighten the 1/2” or 3/4” hardware previously installed,
that hold the braces to the frame. Torque both sides to 44 lb.-ft. (60Nm) (Fig. 17).
8. If equipped with the emissions line previously loosened from the frame, insert the
line holder post into the L-bracket (I) attached to the front or back leg of the upper
left brace (C) (Fig. 18). It may be necessary to move the line holder post forward
or back on the lines to line up correctly with the L-bracket hole. Reattach any line
holders removed forward or behind the axle, if possible, that were removed to aid in
positioning the upper brace.
fig. 16
Torque both sides to
44 lb.-ft. (60Nm).
The spacer must be
parallel to the frame with
the wide portion facing
out toward the wheel.
fig. 17
Emissions line
holder (stock)
(I) L-bracket
fig. 18
M
U
P
Z
Y
Содержание LoadLifter 5000 Ultimate
Страница 24: ...LoadLifter 5000 Series MN 1053 22 Notes ...
Страница 25: ...LoadLifter 5000 Series MN 1053 23 Notes ...
Страница 26: ...LoadLifter 5000 Series MN 1053 24 Notes ...
