Air Lift LoadLifter 5000 Ultimate, Руководство по установке

Страница: 11 / 28

LoadLifter 5000 Series
MN-1053 9
7. Set the lower bracket assemblies aside. Insert two 3/8”-16 x 1.25” carriage bolts (P)
through the two square holes in both upper brackets (D) (Figs. 10 & 11). Also install
one 3/8”-16 x 2.5” carriage bolt (M) through the remaining hole. The head of this
carriage bolt will be hidden once the upper bracket is mounted to the air springs.
8. Make sure the roll plates (G) are on top of both air spring assemblies previously
assembled. Set the driver’s side (left) upper bracket onto the driver’s (left) side air
spring assembly using the holes in the upper bracket designated (Figs. 10 & 12) and
attach to the air spring with two 3/8” flat washers (Z or TT), lock washers (HH)
and 3/8”-24 x 7/8” hex cap screws (GG). Torque the hardware to no more than
20 lb.-ft. (27 Nm).
9. Set the spacer (F) over the long carriage bolt with the wide side facing out (Fig. 12).
Repeat the process for passenger’s (right) side assembly (Fig. 13).
fig. 10
fig. 11
Driver’s (left) side
installation mounting
holes noted.
The flange on bracket
should be up when
inserting the carriage
bolts.
fig. 12
Passenger’s (right)
side installation
mounting holes noted.
Driver’s (left) side upper bracket
installed on the air spring assembly.
fig. 13
Spacer with
wide portion
facing the
outside.
Z or TT
P
P
D
D
F
G
GG
HH
M
M