LoadLifter 5000 Series
MN-1053
10
One of the 3/8”-16 x 1.25” carriage bolts (P) will not be covered by the roll plate and may fall
out. If so, retain for use in the “Attaching the Assemblies to the Frame” section later in this
installation guide.
10. Figure 14 shows the finished assemblies.
NOTE
fig. 14
ATTACHING THE ASSEMBLIES TO THE FRAME
1. Drop the axle or raise the frame up to make room for the assemblies to be put into
position.
2. Set the driver’s (left) side assembly onto the jounce bumper strike plate (Fig. 15). Raise
the axle up just enough to insert the long carriage bolt (M) that is installed in the upper
bracket (Figs. 10 & 11) through the existing jounce bumper hole in the bottom of the
frame. At the same time, line up the upper brace previously installed onto the remaining
two carriage bolts (P) in the upper bracket. Do this just enough for the carriage bolt to
hold the assembly into position on the jounce bumper strike plate.
3. Set the passenger’s (right) side assembly into position on the axle the same way the
left side was positioned (Fig. 15b).
Passenger’s
(right) side
Driver’s
(left) side
fig. 15b
fig. 15
Содержание LoadLifter 5000 Ultimate
Страница 24: ...LoadLifter 5000 Series MN 1053 22 Notes ...
Страница 25: ...LoadLifter 5000 Series MN 1053 23 Notes ...
Страница 26: ...LoadLifter 5000 Series MN 1053 24 Notes ...