Aim HPM 300, Руководство пользователя и информация о гарантии

Страница: 13 / 31

AIM Hybrid Pulse MIG Welder -HPM-350-HD
A IM MIG OWNER’S MANUAL Rev. 2019 :
| 13
CHANGING WELDING WIRE SPOOL
Caution
•
The gear drive can injure or crush fingers in open rolls, Keep Guards in
Place
•
Eye protection must be worn, weld wire can spring off reels when
unrestrained; causing personal injury.
•
Open Hinged door (on right side of welder when facing the front)
•
Choose the correct wire size and alloy for the item to be welded
•
To remove a previously used wire spool that is still connected to the drive
motor.
o
Use wire cutters to cut the wire where it enters the feed drive
o
Secure the wire to the feed spool
o
Open the torch nozzle and remove the contact tip.
o
Pull old wire through the torch cable and liner
o
Properly dispose of old wire scraps.
•
Remove spool holder nut and remove the old wire spool, and properly store
•
Install the new wire spool on the spool holder.
o
Wire must feed off the bottom of the spool
•
Check wire feed rollers to ensure that the proper rolls with the correct
groove size and style (U or V) are installed for the wire size and alloy you
have selected.
o
The wire is fed by the inboard roll groove. The wire diameter that the
groove is made for is marked on the corresponding side of the feed
roll.
o
Flip drive rollers or install the correct ones to get the right grove
aligned with the wire axis.
•
Feed the wire from the new spool into the feed rolls
o
For ease of installation the first few inches of the new wire need to be
strait and any burrs or sharp protrusion removed.
•
Keep the torch cable as straight as possible when feeding a new wire through
the cable.
•
When the wire is through the torch cable the proper size contact tip is
installed and the diffuser cover reinstalled