ahlmann AS 210, Руководство по эксплуатации

Страница: 46 / 116

S220/S221/S230/S231/Z200 6-3
Attachments 6
Figure 6-4
Figure 6-6
Figure 6-5
6.2 Mounting and dismounting attach-
ments without hydraulic connections to loaders
with claw locks (optional equipment)
6.2.1 Standard/lightweight bucket
Mounting
(1) Bring the bucket arm to its lowest position and tip the
quick-change device.
(2) Drive the loader up to the bucket (6-4).
(3) Press and hold the release button for the quick-
change device (4-7/1).
(4) Pick up the bucket using the quick-change device and,
by simultaneously tilting the quick-change device, raise the
bucket until the quick-change device is next to it (6-5).
(5) Release the release button for the quick-change
device (4-7/1).
NOTE
- When the release button for the quick-change
device is pressed, the claws release as long
as the button is pressed.
- The bucket claws engage again when the
button is released.
(6) Check that the device is mounted and locked correctly
on both sides.
DANGER
The bucket is mounted and locked correctly
when the bucket is located next to the quick-
change device and the piston rods of the quick-
change device cylinder can be plainly seen (6-6/
arrow).
Dismounting
(1) Place the bucket firmly on the ground.
(2) Press and hold the release button for the quick-
change device (4-7/1).
(3) Tilt the quick-change device and reverse out.
(4) Release the release button for the quick-change
device (4-7/1).
NOTE
- The claws return to their locking position.
- The type plate is on the rear of the bucket, on
the right-hand side beneath the cross arm.
i
i