Agria 8000 511, Руководство по эксплуатации

Страница: 30 / 40

30
agria
Brush Cutter 8000
5.12 V-belt tension for Travelling
Drive
l
Remove lower cover (D/5)
l
Loosen nuts (D/2)
l
Tension the travelling drive V-belt (D/9) using
the nut (D/3) so far until the V-belt can be
pressed through for about another 10 - 15 mm
and the mowing drive (D/8) remains loose
l
Re-tighten the nuts (D/2)
l
Replace the cover (D/5)
I
Do not tension the V-belt if the nuts (D/2)
have not been loosened!
5.13 Switching for Travelling Drive
l
The setting must be made in such a way
that when the travelling drive is switched on
the machine cannot be driven in a reverse
direction.
l
The setting is made using the Bowden ca-
ble screw (H/2) and the adjusting screw on
the clutch lever (A/2).
5.14 Switching for Mowing Drive
Regularly inspect the setting of the tensioning
roller for mowing drive
l
Remove the front plastic cover (A/9) from
the brush cutter.
Œ
The upper side of the tensioning pulley (G/1)
must be approx. 8 mm under the upper level of
the housing, where necessary carry out an
adjustment by mechanical bending.

When the mowing drive clutch lever is fully
pulled in (A/1) the tensioning pulley (G/1) must
give enough tension to the V-belt (D/8) - the
spring on the cable must be pre-tensioned by
approx. 2 mm in comparison with its slack con-
dition - the vibration of the pulley can be remo-
ved by use of the Bowden cable screw (H/1)
and the adjusting screw on the clutch lever (A/2).
l
Replace the plastic cover (A/9) once more.
5. Maintenance
W
Only operate the machine
if all protective coverings
and safety fittings have been
placed into the safety position
and are in working order!
D
G
H
8 mm
1
2
5