Agria 8000 511, Руководство по эксплуатации

Страница: 29 / 40

agria
Brush Cutter 8000 29
5.9 Protection Liners
Inspect the front protection liner (A/11) and
the rear protection liner (A/16 or D/11) every
time before starting up and replace any
damaged parts.
W
Only operate the machine if all pro-
tective coverings and safety fittings
have been placed into the safety position
and are in working order!
5.10 Knife Change
W
Shut off the engine
Withdraw spark plug connector
Wear protective gloves!
l
Unscrew and take out the knife screw (F/1),
plates (F/2, F/3) and spring washer (F/4) -
when pulling out the knife screw (F/1) hold the
cutter blade (F/5) and take the screw out by
pulling it down fully.
l
Take out the cutter blade
l
The blunt knife can be re-sharpened and
slight bends corrected. - Badly damaged or
bent knife must be replaced by a new one.
l
Fitting stages are carried out in the reverse
order - pay particular attention that the spring
washer (F/4) is correctly centred by using
the centring plate (F/3), tighten the knife screw
to 70 Nm.
l
The safety plate (F/2) must be replaced by
a new one.
W
Do not use the brush cutter if the
knife is not fully fitted and not
tightened in place!
The manufacturer's original design must
be used for all replacement parts.
5.11 Re-grinding the Mowing Knife
W
Wear safety goggles and
protective gloves
After re-grinding re-balance the mowing knife
è
- Service
ç
5. Maintenance
5
5
F
1 Knife screw
2 Safety plate
3 Centring plate
4 Spring washer
5 Cutter blade
6 Cutter boss
agria Order No. see page 36
A/16
or
D/11
A/11