Agilent Technologies N8900 series, Руководство по эксплуатации

Страница: 112 / 119

SCPI Error Messages
A hardware error has occurred on the output.
202 Selftest Fail
A selftest failure has occurred. See selftest failure list for details.
209 Internal communication error
An internal communication error has occurred in the instrument.
210 Frame NVRAM error
A non-volatile RAM error has occurred in the instrument.
308 This setting cannot be changed while transient trigger is initiated
Setting cannot be changed while the instrument is waiting for or executing a trigger sequence.
309 Cannot initiate, voltage and current in fixed mode
Cannot initiate transient generator. Either the voltage or current function is set to Fixed mode.
315 Settings conflict error
A data element could not be programmed because of the present instrument state.
317 Invalid format
The saved state file is corrupted.
318 Configuration error
A master/slave configuration error has occurred.
320 Firmware update error
This may be due to the instrument hardware not being able to support the firmware version.
Command Errors (these errors set Standard Event Status register bit #5)
-100 Command error
Generic syntax error.
-101 Invalid character
An invalid character was found in the command string.
-102 Syntax error
Invalid syntax was found in the command string. Check for blank spaces.
-103 Invalid separator
An invalid separator was found in the command string. Check for proper use of , ; :
-104 Data type error
A different data type than the one allowed was found in the command string.
-105 GET not allowed
A group execute trigger is not allowed in a command string.
-108 Parameter not allowed
Agilent N8900 Series Operating and Service Guide 111