Agilent Technologies E5061B, Руководство по обслуживанию

Страница: 108 / 123

Chapter 5 107
Post-Repair Procedures
Post-Repair Procedures
5.
Po
st-
R
e
pair
Pr
oc
ed
u
re
s
Table 5-2 Post-Repair Procedures
Replaced
Assembly or
Part
Required Adjustments
Correction Constants (CC)
Verification
A11 Source
Module Perform the following required
adjustments using “A11 Source Module”
in Spot Adjustment of the program. “To Execute the Diagnostic Test” on page 31
Frequency Accuracy Test
RF Output Level Accuracy Test
RF Output Level Linearity Test
Crosstalk & System Dynamic Range Test
Noise Floor Test
Trace Noise Test
Dynamic Accuracy Test
Compression Test
IF Linearity at 1.195 GHz Test
IF Linearity at LF Test
Uncorrected System Performance Test.
A3/A4 Receiver
Module Perform the following required
adjustments using “A3/A4 Receiver
Module” in Spot Adjustment of the
program.
“To Execute the Diagnostic Test” on page 31
Frequency Accuracy Test
RF Output Level Accuracy Test
RF Output Level Linearity Test
Crosstalk & System Dynamic Range Test
Noise Floor Test
Trace Noise Test
Dynamic Accuracy Test
Compression Test
IF Linearity at 1.195 GHz Test
IF Linearity at LF Test
Uncorrected System Performance Test.
A10 Analog
Motherboard No adjustment needed Inspect the Booting Process
When the symptom of failure is out of
specification, perform the performance test.
A50 CPU
module No adjustment needed Inspect the Booting Process
DSP Card Perform the following required
adjustments using “DSP board” in Spot
Adjustment of the program.
Writing ID
Inspect the Booting Process
Executed all of the performance test.
“To Check the Front Panel” on page 38
“To Check the External Trigger Input” on
page 41
Front Panel Board No adjustment needed “To Check the Front Panel” on page 38
Handler I/O
Board No adjustment needed “To Execute the Diagnostic Test” on page 31