Agilent Technologies E364 A Series, Руководство пользователя

Страница: 166 / 207

Appendix Service Information
Recommended Test Equipment
165
Ser
vice
In
for
mat
ion
Recommended Test Equipment
The test equipment recommended for the performance verification and
adjustment procedures is listed below. If the exact instrument is not available,
use the accuracy requirements shown to select substitute calibration
standards. If you use equipment other than that recommended in Table A-2,
you must recalculate the measurement uncertainties for the actual equipment
used.
Table A-2 Recommended Test Equipment
*
To find the accurate resistance, it is recommended to use a current monitoring resistor after calibration.
1
E3640A model,
2
E3641A model,
3
E3642A model,
4
E3644A,
5
E3643A,
6
E3645A model.
Instrument Requirements Recommended Model Use
GPIB controller Full GPIB or RS-232
capabilities Agilent 82341C interface card
or equivalent Programming and readback
accuracy
Oscilloscope 100 MHz with 20 MHz
bandwidth Agilent 54602B Display transient response
and ripple & noise waveform
RMS Voltmeter 20 Hz to 20 MHz Measure rms ripple & noise
Cable (BNC to BNC) 50 ohm, 9 inch (23 Cm) Agilent 10502A or 10503A if
the 10502A is not available Measure rms ripple & noise
(CV PARD, CC PARD)
BNC (Female)
Bulkhead Receptacle Isolated Ground.
Nominal impedance: 50 Ohm Pomona Model 5148 Measure rms ripple & noise
(CV PARD, CC PARD)
Split Ferrites For use with round cable Steward Co. 28A2029-0A0 Noise coupling reduction
Digital Voltmeter Resolution: 0.1 mV
Accuracy: 0.01%
Agilent 34401A Measure dc voltages
Electronic Load Voltage Range: 240 Vdc
Current Range: 10 Adc
Open and Short Switches
Transient On/Off Agilent 60503B Measure load and line
regulations and transient
response time.
Resistive Loads (R
L
) (2.7 , 150 W/13.5 , 150 W)
1
(43.8 , 300 W/120 , 300 W)
2
(1.6 , 300 W/8.0 , 300 W)
3
(1.0 , 300 W/5.0 , 300 W)
4
(25 , 300 W/75 , 300 W)
5
(15.9 , 300W/46.2 , 300W)
6
Measure ripple and noise
Current monitoring
Resistor (Shunt) - R
M1
(0.01 , 0.1%)
*
ISOTEK Co. Model: A-H or
equivalent Constant current test setup
Current monitoring
Resistor (Shunt) - R
M2
(0.2
W
, 0.1%)
*
ISOTEK Co. Model: RUG-Z
or equivalent Measure current rms ripple &
noise