Agilent Technologies Agilent G3215A, Руководство пользователя, Страница: 31 / 42

Installation 2
Mass Spec Bench User Guide 31
Step 7. Move the Mass Spec Bench to its final position
1 When the LC/MS or GC/MS instrument has been placed upon the Mass Spec
Bench, move the Mass Spec Bench to it final installation position.
2
When the Mass Spec Bench is in the desired position, lower the extendable
pads inside the corner castors.
To extend the pads, pull the handle out and turn the ratchet in the
clockwise direction. If the ratchet is not turning in the correct direction,
flip the switch to change the ratchet direction.
Extend the pads so that the castor wheels no longer touch the floor.
3 When the corner castors have been extended, extend the feet on the pump
tray.
This action isolates the rough pump vibration from the Mass Spec Bench.
Note that access to the rear castors can be difficult. Use a 3/4 wrench to
extend the feet of the pump tray so that the pump tray is no longer in
contact with the Mass Spec Bench. The pump tray needs only 1/8-inch of
height above the support rails.
Figure 22 Extendable Rubber Feet
The ratchet handle must be
pulled out in order to extend
the pads.