Agilent Technologies Agilent G3215A, Руководство пользователя, Страница: 27 / 42

Installation 2
Mass Spec Bench User Guide 27
8
Route the Tygon exhaust hose and power cord for each pump through one
of the remaining ports. Repeat if there is a second pump.
The exhaust hose and power cords use the same ports, so use the foam
knock outs to fill the remaining area of the hose port on the Mass Spec
Bench. This action prevents excessive amounts of cooling air from blowing
out these ports.
9 If the pumps are new and require oil before being turned on, fill the pumps
at this time with the correct amount of oil.
10
Install the round foam plugs (from step 7 on page 26 ) around the exhaust
hoses to plug the holes as much a possible. Use a knife to cut the foam to
wrap around the hose.
11 After the pumps are installed, close the door on the pump closure.
12
Remove the protective film and any other stickers on the top black phenolic
surface where the instrument is going to be installed.
13 Follow the instructions in the system installation guide to set up the LC/MS
or GC/MS instrument on the Mass Spec Bench.
Figure 18 Dual foreline hose installation
C A U T I O N
Wipe up any oil spilled during the filling process.
WA R N I N G
Storage of oily rags, paper towels, excess or used oil, or solvents inside the pump
enclosure is strictly prohibited as these materials present a fire hazard.