
Starting the DR Detector
To start the DR Detector:
1.
Check if the DR Detector cable is connected to the System Control Unit.
2.
Check if the power cable of the System Control Unit is connected to the
mains power.
3.
Turn on the detector.
Note
:
Before operating the detector, start up the NX
workstation.
Press and hold the power button for 1 second.
Figure 9: Power button
After startup the power indicator is green and the status indicator is
orange.
4.
Turn on the System Control Unit using the power switch.
The status indicator is green.
Depending on the configuration, the System Control Unit may not be part
of the system.
The DR Detector is ready.
Before exposure make sure to check the equipment daily and confirm that it
works properly.
Related Links
on page 73
60
| DX-D 60C, DX-D 60G | Getting started
0294B EN 20190221 1131