AGFA 1, Руководство оператора

Страница: 33 / 54

: ANAPURNA XL² OPERATOR MANUAL
A B]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
33
] 8/08/2008
]
Remark: The engine has also a parameter ‘Mark Center Offset’ for this which
is default set on value ‘5000’ means 2.5 cm besides the image edge.
This value can be changed by the technician, but if this value is made higher,
the bidirectional alignment value has to be changed accordingly, and you will
be restricted in total image width if you want to print at another time at full
width of the engine onto your media (the extra displacement counts off of your
maximum image width). For that we advise to add the blanco space in
Wasatch and leave the engine setting unchanged.
9.2.3. Vacuum
With rigid media, the vacuum settings must be chosen according the covered area on
the conveyor belt. When printing on two rigid media, activate both the vacuum tables
(1&2). (more info: see chapter 7.1)
9.3. Media Tension Bars
The engine has got one roller bar at the front, and one at the back.
They are located underneath the front- and back-covers. These bars will help to keep
the media flat while it’s been transported on the conveyor belt.
It can be used on Roll media, as well as on rigid media.
You can lower the bars, by switching the “FRONT” or “REAR” buttons.
When you’ve taken out a bar, and want to re-insert it:
Make sure both side’s are positioned as high as possible into the left
and right unit, then gently lower both sides, the bar must stay completely
horizontal for best use.