:
ANAPURNA XL²
OPERATOR MANUAL
A
B]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
32
]
8/08/2008
]
With the lower “Media Set” button, you drop all the 6 top alignment pins (pins
indicated under number 3 in the above picture). These are the front pins to which
you put the front edge of your media.
After placement of the media onto the belt, you have to switch the vacuum on,
and move all the pins back upwards.
While Media Set pins are lowered, the blue light will lighten up on the tower, and
neither carriage movement nor printing is possible.
For longer media, the side guiders with rolls can be used located on the guider at
the rear of the vacuum table.
9.2.2.2. Top and Left Margin Setup:
The “A” and “B” positions, the “origin-point” at the corner of your media, are
known distances. The “A” point has as approximately position: Top margin = 300
mm and Left Margin = 50 mm. Depending on the position onto the media where
the image has to be printed, you have to add the image offset to these numbers.
These numbers can be entered in the Control program.
Image placement for printing on two rigid media, must be done on Rip level.
Important
When printing on heat sensitive media, always make sure the right
UV lamp is going passed the media, on the point of returning.
(otherwise there will be more heat at the left side of the media,
which can cause media cockling or produce a yellowish shine on some media)
This can be arranged on the Rip level by entering a blanco space at the
right of the pictures.
Содержание 1
Страница 1: ... ANAPURNA ANAPURNA ANAPURNA ANAPURNA XL XL XL XL OPERATOR MANUAL version 1 0 AB ...
Страница 5: ... ANAPURNA XL OPERATOR MANUAL AB 5 8 08 2008 2 2 Rear view parts locations ...
Страница 7: ... ANAPURNA XL OPERATOR MANUAL AB 7 8 08 2008 2 3 Head Carriage view parts 2 4 Signal tower ...
