:
ANAPURNA XL²
OPERATOR MANUAL
A
B]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
34
]
8/08/2008
]
10
10
10
10.
.
.
. Head Base
Head Base
Head Base
Head Base –
–
–
– Height Control
Height Control
Height Control
Height Control....
10.1. Automatic “Head Base Height” Setup
This is done in the “Head Gap Control”, which can be found in the Setup Parameter
window.
Check or change the following Parameters to set the Head Base Height:
Gap:
Enter the value that you want the “Head Base” to be above the media surface.
(Recommended value: 1.5mm; For heat sensitive media, you can go higher to
avoid that too much heat is accepted by the media, and as a result the media
is extended and can touch the head or is printed with bad quality.
Change of this value requires however other values as ‘offset’ and ‘bi-
alignment offset parameters.
Don’t forget to save the Setup parameter list to keep the change.
Содержание 1
Страница 1: ... ANAPURNA ANAPURNA ANAPURNA ANAPURNA XL XL XL XL OPERATOR MANUAL version 1 0 AB ...
Страница 5: ... ANAPURNA XL OPERATOR MANUAL AB 5 8 08 2008 2 2 Rear view parts locations ...
Страница 7: ... ANAPURNA XL OPERATOR MANUAL AB 7 8 08 2008 2 3 Head Carriage view parts 2 4 Signal tower ...
