AGCO Glencoe SOIL FINISHER SF4600, Руководство оператора

Страница: 14 / 36

OPERATION
FIELD OPERATION
Warning! Never allow anyone to ride on this
equipment. Clear the area of
bystanders before starting operation.
Warning! Avoid sharp turns using brakes. Drive
slowly over rough ground, side hills
and around curves to avoid tipping.
Preparation for field use.
Move the tractor hydraulic levers which control both
the axle cylinders and the winglift cylinders rearward
as if to raise both the unit and the wings to help
make sure there is no air in the hydraulic lines.
Remove the two main wing lock pins (A) and store in
position (D). Move the hydraulic lever forward and
slowly unfold the wings. Make sure the wing
cylinders are fully extended to allow the wings to
follow the contour of the ground.
IMPORTANT: On tip down models:
1. Remove main wing lock pins (A) and store in
position (D).
2. When starting the unfolding process, make sure
the tip down wing locks (B) remain engaged so
that the main wings unfold first.
3. When the main wings are on the ground, stop
applying the hydraulic power. At this point,
visually confirm that the tip down wing locks are
disengaged. Machine damage will occur if the
tip down wing locks do not disengage.
4. Then slowly continue the unfolding procedure
until the unit is completely unfolded.
Initial Frame Leveling
Move the hydraulic lever that controls the axles
forward to lower the implement to the ground. At this
point, adjust the hitch turnbuckle (C) to level the
frame so it is parallel with the ground. This will help
insure that all the shanks are cutting at the same
depth.
10
D
D
GNC0010
B
GNC0011
C
GNC0012A
A