34
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Regulations
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest
edition.
In Canada, installation must conform with the
current Natural Gas Installation Code, CAN/CGA-
B149.1 or the current Propane Installation Code,
CAN/CGA-B149.2, and with local codes where
applicable.
This range has been design-certified by CSA
International according to ANSI Z21.1, latest edition
and CAN/CGA-22.2 latest edition.
Read the instructions before installing or using
this appliance. This range becomes hot in use,
the cooktop burners produce exhaust gases. Take
safety precautions - see the safety warnings in the
User Guide, which should be read together with
this installation guide.
The range must be electrically grounded in
accordance with local codes or, in the absence
of local codes, in accordance with the National
Electrical Code (ANSI/NFPA 70, latest edition).
In Canada, electrical grounding must be in
accordance with the current CSA C22.1 Canadian
Electrical Code Part 1 and/or local codes. See
‘Electrical Connection’ in this section.
Important
• Observe all governing codes and ordinances.
• The range must be properly grounded.
• Save these instructions for the local electrical
inspector’s use.
For Your Safety
Do not store or use combustible materials, gasoline
or other flammable vapors and liquids in the
vicinity of this or any other appliance.
If you smell gas
• Open windows.
• Don’t touch electrical switches.
• Extinguish any open flame.
• Immediately call your gas supplier
Tools
You will need the following tools
1. Electric drill
2. Masonry drill bit & anchors (only required if
fitting the range on a stone or concrete floor)
3.
Steel tape measure
4. Phillips head screwdriver
5.
Flat head screwdriver
6. 4mm & 3mm Allen keys
7. Spirit level
8. Pencil
9. Open-end or adjustable wrench
10. Pencil and ruler
11. Pipe wrenches
Materials
Additional materials you may need:
• Gas line shut-off valve
• Pipe joint sealant or UL-approved pipe thread
tape with Teflon* that resists action of natural
and LP gases. *Teflon: Registered trademark of
DuPont
• Flexible metal appliance connector (1/2’’ I.D.).
A 5-foot length is recommended for ease of
installation but other lengths are acceptable.
Never use an old connector when installing a
new range.
• Flare union adapter for connection to gas supply
line (3/4’’ or 1/2’’ NPT x 1/2’’ I.D.)
• Flare union adapter for connection to pressure
regulator on range (1/2’’ NPT x 1/2’’ I.D.)
• To protect any floor covering under the range a
sheet of 1/4’’ thick ply wood or equivalent large
enough to stand the range on
