AGA legacy 110 Dual Fuel Range, Руководство пользователя и инструкции по установке

Страница: 32 / 40

32
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Servicing Notes
When servicing or replacing gas carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion. When
checking for gas leaks do not use washing up liquid -
this can corrode. Use a product specifically
manufactured for leak detection.
Do not use re-conditioned or unauthorised gas
controls.
Disconnect from electricity supply before commencing
servicing, particularly before removing any of the
following: facia panel, side panels, hotplate tray, or any
of the electrical components or cover boxes. Before
electrical reconnection check that the appliance is
electrically safe.
1. To Remove Facia Panel
Disconnect from electricity supply.
Pull off all the control knobs.
Open the grill door and R H oven door and remove the
6 fixing screws underneath the control panel. NB some
models have a plate under the facia held in place by
the bottom fixing screws.
Slide the facia panel to the right and then pull forward.
Disconnect leads from back of switches and timer. Lift
facia panel clear of cooker.
Reassemble in reverse order. When replacing leads
refer to the wiring diagram. Check operation of timer,
ignition, and oven light switches.
2. To Remove Hotplate Trays
Disconnect from electricity supply.
Pull the cooker forward to gain access to the rear
Left hand tray
From the rear remove the 3 screws securing
the flue grille to the hotplate tray. Remove pan
supports, burner heads and caps. Remove
the 4 screws and washers holding the hotplate
tray to the frame. Raise the front of the
hotplate then withdraw.
Right hand tray
From the rear remove the screws securing the
flue grille to the hotplate tray . If the LH
hotplate has not been removed, slacken the
screws holding the L H tray. Remove pan
support, burner head, caps and trim rings.
Remove the 4 screws holding the Wok burner
to the hotplate. Remove the two screws and
washers holding the RH tray to the frame.
Press the Wok burner down slightly and,
taking care not to damage the Wok burner
electrode, slide the tray about 30mm to right to
clear the locating brackets on the R H side. Lift
tray slightly at the front and taking care not to
stress the Warmer/lead junction, disconnect
the leads to the Warmer neon and separate
the leads at the piggybacks. Withdraw the
hotplate.
Reassemble in reverse order ensuring that the leads
are reconnected. When replacing the RH hotplate take
care not to damage the ignition electrode of the Wok
burner.
It is important that the rear fixing screws are refitted as
they from part of the cooker earthing.
On some models there is a separate plate.
A flue grill, B cooker backsheet, C earthing/fixing
screws
On others it is a tag on the cooker backsheet.
It is important that the tag is on the outside and that
both fixing screws are fitted.
A flue grill, B cooker backsheet, C earthing/fixing
screws