Page 12
AGA Ellesmere Electric Standard Stove
Installation & User Manual
UNPACKING AND TESTING APPLIANCE
Carefully remove the appliance from the box.
Prior to installing the appliance, test to make sure the appliance operates properly by
plugging the power supply cord in the socket on the back of the stove and then directly into a
240 Volt wall socket (not an extension lead or a multi-plug in a wall socket)
Test all aspects of its operation (manual switches, remote and heater) to make sure all
components are operating correctly.
As with most electronic devices, your new electric stove has been designed to operate at
temperatures between 5
℃
(41
℉
) and 35
℃
(95
℉
). During the cold winter months, allow the
stove to reach a minimum room temperature of
5
℃
before turning it on.
NOTE: There may be a trace of odour during the first time you use this stove. This is
caused from the paint finish curing, if the smell is strong open the windows and
operate the stove on the full heat setting for 30 to 45 minutes to allow the paint to cure,
children, the elderly or pets should not be allowed into the room during this period
WARNING
– ELECTRIC SHOCK HAZARD
It is the customers responsibility to contact a qualified
electrical installer to make sure the electrical installation
is adequate and in conformance with the regulations.
Take special care when cutting holes in walls or floor.
Electrical wires may be behind the wall or floor covering
and could cause an electrical shock if you touch them.
Locate any electrical circuits that could be affected by the
installation of this product and disconnect power circuit
WARNING: THIS APPLIANCE MUST BE EARTHED.
DO NOT use an extension lead with this appliance.
The appliance is designed for the voltage stated on the
CE data plate.
Recommended but not mandatory to fit an individual Residual
Current Device (RCD) to the ring main supply circuit to this stove.
Please Hand this Manual to the customer/User for retention and
future instructions in the safe operation of the appliance.
