AFG 18.0AXT, Руководство пользователя

Страница: 8 / 21

BEFORE
YOU BEGIN
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ASCENT
TRAINER
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASCENT
TRAINER
OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ROD BEARING SHAFT
BOLT (T)
NUT (G)
WASHER (L)
BOLT (N)
SPACER
SPACER
ROD BEARING
SHAFT
LINK ARM
LOWER
HANDLEBAR
WASHER (L)
18 mm
Qty: 2 BOLT (N)
45 mm
Qty: 2
WASHER (U)
18 mm
Qty: 2 BOLT (T)
45 mm
Qty: 2
ROD BEARING
SHAFT
Qty: 2 SPACER
Qty: 4
ROD BEARING
SHAFT
?? mm
Qty: 2
SPACER
?? mm
Qty: 4
NUT (G)
8 mm
Qty: 2
NUT (V)
8 mm
Qty: 4
HARDWARE BAG CONTENTS:
ASSEMBLY STEP :
Open HARDWARE BAG 9 .
Slide 1 ROD BEARING SHAFT into the joint end of right LINK ARM .
Fit 1 SPACER on each side of each ROD BEARING SHAFT after the ROD BEARING SHAFTS are in LINK ARM .
Attach right LINK ARM to the right LOWER HANDLEBAR using 1 BOLT (N) , 1 WASHER (L) and 1 NUT (G) .
Repeat on opposite side.
A
B
C
D
E
ASSEMBLY STEP
CRANK
PACKAGING PLASTIC
WASHER (D)
WAVY WASHER (J)
BOLT (C)
CRANK CAP
SWING CAP
TOP HANDRAIL
WASHER (D)
BOLT (C)
AXLE
WASHER (D)
SWING CAP
BOLT (C)
RIGHT SWING ARM
PEDAL ARM
LINK ARM
WASHER (D)
25 mm
Qty: 6 BOLT (C)
16 mm
Qty: 6
WASHER (Q)
25 mm
Qty: 2 BOLT (P)
16 mm
Qty: 2
WAVY WASHER (J)
29 mm
Qty: 2 AXEL
Qty: 2
HARDWARE BAG 8 CONTENTS:
ASSEMBLY STEP 8:
Lay waste packaging plastic over the BASE RAIL . This will prevent the PEDAL ARM assembly from scratching
the ascent trainers paint.
Open
HARDWARE BAG 8
.
Attach right SWING ARM to TOP HANDRAIL using 2 SWING CAPS , 2 BOLTS (C) , 2 AXLES and 2 WASHERS (D) .
Attach the right PEDAL ARM to the right CRANK using 1 WAVY WASHER (J) , 1 WASHER (D) and 1 BOLT (C) .
Attach the
CRANK CAP
to the
CRANK
.
Repeat on opposite side.
A
B
C
D
E
F
ASSEMBLY STEP 8
LEAVE BOLTS LOOSE until you have finished STEP D .
18.0 AXT Rev.2.4.indd 14-15 9/24/08 1:42:10 PM