Afag CR 12, Перевод оригинальной инструкции по монтажу

Страница: 35 / 50

CR 12 - CR 16 - CR 20 - BA-vers.4.0 gb 20190630 35
3.3.0 Shock absorber adjust
Maximum damping efficiency
The maximum damping efficiency is achieved when the shock absorbers are
completely turned in (mechanical stop).
Reduced damping efficiency:
The damping efficiency is reduced when the shock absorbers are turned back.
This is recommended if the loads to be moved are low and/or at slow rotational
speeds.
Adjustment of the end position damping
1. Undo hexagon nut at the shock absorber
2. Screw the shock absorber at the small hexagon in our out (on both sides)
(damping gets harder when screwing in and softer when screwing out).
If damping is not yet perfect the air-core choke can be adjusted.
The shock absorber can be removed if it is to be replaced. The module may not be
under pressure! (Air away)!
The threaded sealing ring must be screwed onto the shock absorber. Pushing
the threaded sealing ring over the shock absorber will damage the sealing lips
and cause the module to leak.
Reducing the damping by turning the shock absorber
back
Removing the shock absorber
Shock absorbers
completely screwed in
Adjusting
stop
* Sealing ring
Removing the shock
absorber