Albert 2 User Manual
February 2018| ©AEVI International GmbH
PAGE 23/46
•
Plug the country specific AC power cable into the power pack and the other end into a wall
outlet.
•
Plug the other end of the cable into the cradle
•
When the cradle is connected, put the Albert 2 onto the cradle. After a few seconds, the LED
turns on and the loading process starts.
7.3
Initial configuration
All values have to be set up manually by the user (merchant) or technician. The terminal
configuration requires set up of one or more of the following:
•
Wi-Fi and/or 4G connections (a connection is always required)
•
If required by your configuration, set up any other values, e.g. Terminal Id or Merchant Id
•
If required by your configuration, set up of one or more passwords
It might be necessary first to insert the SIM (follow the instructions of your mobile network operator).
Follow the instructions of your payment service provider on any other first time set up activities that
are required. These could include first-time logging in to the acquirer’s remote systems, as advised by
the payment service provider.
7.4
Normal Power-up
After the first time power up, subsequent power-ups will enable the device to complete transactions
immediately. You don’t need to complete any other configurations, unless the terminal requires
uninstallation or reinstallation.
The procedure for a power up is as follows:
•
Press and hold down the power button for about 4 seconds until the white camera LED and
the red tamper LED is flickering shortly. If the device was charging while OFF, the screen
shows a battery symbol that the device is charging.
•
Then a AEVI logo appears on the screen
