ScoopTeam - User manual - Draft 0002
55
First insert the SIM card in the ScoopTeam (the unit must be
powered off
for this), and connect at least
one antenna to the unit. See how to proceed on page 29, “Drawer for SIM card
”. Power up the
codec, enter the sub-menu
Network
/
Mobile settings (Internal)
and touch
PIN Code
. Enter the PIN
code of the SIM card using the virtual keypad and touch
OK
. Touch the
icon to confirm the entry.
This is useless, of course, if the card’s PIN code is blank or disabled. Conversely, if you enable
PIN Save
you will not need to enter the PIN code again later, even if the unit is switched off.
The network access must be configured using the
Network
/
Mobile settings (Internal)
menu. You can
find details in 4.6.2, Network sub-menu, Mobile settings (internal) section; the following settings are
suitable in most occasions:
Leave
Preferred Radio Access technology
in the “Auto” setting.
Leave
Preferred Network Operator
in the “Auto” setting, except if there is a definite reason not
to do so.
Mode
must be set “Audio over IP”.
In the
Audio over IP
section, DATA service should be active, and the other parameters are set
automatically.
However, if the
Access Point Name
is not set, or its value is not appropriate, you can enter a
new value.
Afterwards, touch the
icon to confirm the entry.
Select “Middle” for the
Network Quality
setting.
After having performed these settings, you can check the status of the mobile registration in the
Status
/
Mobile
sub-menu: operator, radio access technology and signal strength, status of the data connection.
In addition, in the operation pages the status bar includes status icons related to the mobile network.
Mobile settings (USB device) (
NYA
)
TBD
Wi-Fi settings (
NYA
)
TBD
4.4.3. Setting the coding configuration
Access level: Expert
The coding configuration is done via the
Coding
menu. There is a shortcut button
The
Coding
/
Codec 1
sub-menu deals with the settings for Codec 1.
The
Coding
/
Codec 2
sub-menu deals with the settings for Codec 2.
It is disabled when the codec mode
is “Single Codec” (see above in 4.4.1, case 1 and case 2).
When it is active, it provides the same
parameters as the menu for Codec 1, but the settings are independent from each other.
Each codec on the “Connection” page includes a “Coding” shortcut button that leads directly to the
appropriate
Coding
/
Codec n
sub-menu when touched.
The main setting is of course the
Algorithm
: touch this row and the list of available algorithms is
displayed; pick the desired one. Proceed with the other parameters as needed. You can find more
details in 4.6.3, Coding sub-menu.
You will notice that for every setting, the proposed list depends on the current network, and depends on
the values for the other parameters.
As a result, it is not possible to build an invalid combination of
coding parameters.
When the configuration is complete,
make sure to touch the
icon
to confirm the entry. Conversely,
you can cancel the whole configuration by exiting the sub-menu without doing this.
