20
6. Securely fasten the control horn to the aileron
with six wood screws.
Note:
CA glues have a fast drying time.
Remember to work quickly.
7. Tape the aileron to the wing using masking tape
as shown below. Adjust the length of the push-
rod so that the servo arm is parallel to the aileron
hinge line and the trailing edge of the aileron is
even with the trailing edge of the wing in the
neutral position.
Note:
Control horns have been set at a slight offset
to provide full power at full deflection.
9. Use the opposite end of the adjustment wrench
to tighten the pushrod jam nuts against the ball
links. This will prevent the pushrod from turning
in flight.
8. Use the supplied adjustment wrench to adjust the
pushrod as shown below.
