28
Aeroworks 30cc Freestyle Extra 260 Assembly Manual
THROTTLE SERVO INSTALLATION
1. Gather the throttle items as shown below:
Required Parts
◊
1 - Prebuilt Plywood Servo Mount
◊
1 - 4-40x300mm Threaded Pushrod
◊
1 - 4-40 Threaded Solder Coupler
◊
2 - 4-40 Ball Links
◊
2 - 4-40x16mm Hex Head Bolts
◊
2 - 4-40 Lock Nuts
◊
1 - Brass Spacer
◊
2 - 3mm Flat Washer
Required Parts -Not Included
◊
1 - Throttle Servo
◊
4 - Servo Mounting Screws (Micro Fastener
Part number
STW0209
recommended)
◊
1 - 3/4” Servo Arm
Required Tools and Adhesives
◊
1 - Pencil/Felt Tip Pen
◊
1 - Phillips Screw Driver
◊
1 - 5/64” Ball Driver
◊
1 - Electric Drill
◊
1 - 1/16” Drill Bit
◊
1 - 7/64” Drill Bit
◊
1 - Rotary Cutting Tool with Cutting Disk
◊
1 - Wire Cutter
◊
1 - Soldering Iron
◊
1 - Silver Solder
“Sta-Brite Recommended”
◊
1 - 80 Grit Sandpaper
◊
1 - .34oz Bottle Blue IC-Loc Thread Locker
2. Mark the location of the throttle pushrod on the
firewall as shown.
3. Use a drill bit to drill the holes for the throttle
pushrod.
4. Install the throttle servo in the preassembled la-
ser cut mounting tray as shown below.
Note:
It may be necessary to remove the bottom
corner of the servo mounting tray as shown.
This will allow the mounting tray to fit over
the reinforcement tri-stock.
5. Apply 5 minute epoxy to the side of the servo
mount that will be in contact with the engine box
side.
