12
Aeroworks 30cc Freestyle Extra 260 Assembly Manual
11. Place elevator control horns into the pre-cut slot
with the base plate installed. Use a ballpoint pen
to mark the location of the base plate as shown
below.
12. Use a hobby knife to carefully remove the cover-
ing. Take care not to cut to deep and damage the
wood underneath the covering.
13. Final picture of removed covering shown below
14. Apply 5 minute epoxy into the control horn
mounting slots and the base plate mounting loca-
tion as shown.
9. Use 80 grit sandpaper to scuff the carbon control
horn and base plate where it will be glued to the
elevator as shown below.
10. Assemble the pushrod and control horn assem-
bly as shown. The ball link goes between the
left and right sides of the control horn sides and
is secured with a nylon lock nut. Brass spacer
goes between servo arm and ball link and is not
installed between the right and left control horns.
