Aeroworks 30cc Freestyle Extra 260 Assembly Manual
13
19. Final elevator servo installation shown below.
Repeat all previous steps for the remaining ele-
vator assembly.
Note:
On metal geared servos use Loctite for all
servo arm mounting screws.
Builders Tip:
If using Hitec Servos, replace phillips head servo
arm screw with a socket head screw. This will allow
for easier removal at a later date. These screws can
be purchased from Micro Fasteners part number:
SCM2508
16. Tape the elevator in place as shown. This will
help keep the elevator centered while making the
initial linkage adjustments.
18. A pushrod adjustment wrench has been in-
cluded, this will allow the pushrod length to be
extended or shortened with out removing the
servo arm. Adjust the pushrod length so the con-
trol surface is neutral when the servo arm is 90
degrees to the servo case.
17. Install ball link to 1 1/4” servo arm, correct in-
stallation of ball link to servo arm shown below.
Note:
Flat washer will prevent ball link from
coming loose from brass ball.
15. With elevator centered in natural position, en-
sure the mounting hole of the control horn is
centered on the hinge line as shown. Double
check this alignment while the epoxy cures, it is
very important that the control horn is correctly
aligned with the hinge line.
