AeroVironment TurboDX EVSE-DX, Руководство по установке

Страница: 8 / 24

4
PACKAGING CONTENT
Inside the box you’ll find:
1
X
- TurboDX EV Charging Station
6
X
- M5 x 10 mm Electronics Cover Mounting Screws
2
X
- #10 x 2” Mounting Screws with Sealing Washers
NOTE: If you are missing any of these parts, please call Customer Service 1-888-833-2148.
REQUIRED TOOLS (not included)
The following tools are required for installation:
1.
Electronic Stud Finder
2. Measuring Tape
3. Carpenter’s Level
4. Drill
5.
T25 Torx Bit
6. Hole Saw (with pilot drill) or Step Drill
7. Slotted Screwdriver
INSTALLATION PREPARATION
1.
Before installation, check for proper utility power requirements
and disconnect power. Prepare charger mounting site.
• Turn off circuit breaker at power distribution panel and disconnect switch (if
installed) before installing this charger.
• Check upstream circuit breaker; use table below to determine proper circuit
breaker rating.
• Installation should be completed by a licensed, qualified electrician.
Installation must comply with the provisions of all local electrical codes in
country of installation.
16A 20A
32A 40A